Uppipe for Ford 2008-2010 6.4L Powerstroke Diesel

For 2008,2009,2010 Ford 6.4 Powerstroke Diesel

Note: Due to differences in the up-pipes these will not work with your factory 6.0L exhaust manifolds.

Please refer to the figure below. The original 08-10 The original 6.4 Powerstroke engine will use two kinds of Up-pipe, if your engine uses "Factory 6.4 Powerstroke", this product is suitable. If your engine uses "Factory 6.0 Powerstroke", then this product is not suitable. Please Note!!!!!!

The downpipe on your turbocharged vehicle is directing the exhaust gases out of the turbine housing into the exhaust system. An aftermarket downpipe will typically be larger in diameter and either uses a high-flowing catalytic converter or remove the catalytic converter altogether.

By removing the factory downpipe and replacing it with a high flowing unit you are allowing the turbo to more efficiently move gases away from the turbine which creates more power. Since the factory restrictions are now gone you can increase the boost on the vehicle as the factory downpipe is a choking point for performance.

Material: T201SS (other material available)

OD: 2"

Technics: Mandrel bend

Weld: TIG Welding

Surface treatment: Polish (customize available)